A little routing downtime occurs when I convert the etherchannel but then it is worth the result. So I guess I wasn't doing it wrongly, but it was a bug that causing the issue and luckily we still have workaround for that. Flow monitor applied to the VLAN and then everything works as expected. What I did then is converting my etherchannel to L2, then use SVI for 元 communication. They didn't say anything about 3650, however since I think that they both running in the same IOS XE, I believe that this applies to 3650 as well. It is said there's a bug when applying flow monitor to a 元 etherchannel in Cisco 3850 that causes flow traffic invisible. It made me believe that I've done things wrongly but then I stumbled upon this bug article -> CSCut08292 However, when I did it that way, there was no flow traffic sent at all. The command was accepted successfully on the physical interface. I've tried changing netflow source to a loopback interface and the apply the ip flow monitor to a physical ports that are member of the etherchannel but it never send any flowĪs there is still no answer to this question, I will follow up my own post.Īfter days of digging and trial & error, what I thought could be the solution to this issue was applying the ip flow monitor command on physical interfaces that are the member of the etherchannel (instead of applying ip flow monitor on the port channel interface). Netflow config: flow exporter Netflow-to-Orion Port-channel config: Sw3650-01#sh run int po11 % Flow Monitor: Flow Monitor 'Netflow-Monitor-In' flexible netflow not supported on port channels Response that I got: Sw3650-01(config-if)#ip flow monitor Netflow-Monitor-In input Please advise how can I get this flow configuration to work in Port-Channel interface. I have a Cisco 3650 with IOS XE version 03.07.03E and unable to implement flow monitor on a 元 port-channel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |